Skip to main content

Collision Sensor | small payload | QS-25

Collision detector QS-25: Industrial safety and enhanced reliability

Collision sensor QS-25 for trip collision sensor force

With moments trip points from 0.3 to 30 Nm, small payload collision sensors will be the most appropriate models for your applications such as pick and place or dispensing.


  • Dynamically variable collision sensor that operates on air pressure. Breakaway threshold adjusts to match the working force ranges of robot/application
  • Non compressive, metal to metal seals for reliable and consistent operation
  • Opening of QuickSTOP air chambers at impact, pressure exhaust and switch signal stop the robot

Advantages

  • Senses angular and compressive forces. QuickSTOP’s unique design offers protection in X, Y and Z axis
  • Linear and angle strokes available to remove the forces from end of arm tooling and robot wrist at trip point
  • Performance readiness is monitored by QuickSTOP. When pressurized, the switch indicates that the QuickSTOP is reset in proper position

Benefits

  • Minimize down time, quick reset, no need for recalibration, stopping robot at source of impact allows for easy identification of cause
  • Minimize robot and expensive end of arm tooling damage during robot programing. A must for any education or robot training cell
  • Easy to implement, simple to adjust pressure level according application, quick return on investment

QS-25
Repeatability - X, Y 0.013 mm
Repeatability - Z 0.013 mm
Rotational Repeatability ± 0.024 °
Axial Compliance Vertical 3.400 mm
Compliance Angle 5 °
Rotary Compliance No limit
Torque Trip Point 1.0 - 6.4 Nm
Moment Trip Point 1.0 - 6.4 Nm
Weight 0.260 kg
Diameter 63.500 mm
Profile 32.000 mm
Center of Mass 18.600 mm
Average response time 4-7 ms
Dust Protection Foam collar supplied
Switch High reliability aircraft snap acting type. UL/CSA approved. Average cycle life : 7 million cycles
Operating Pressure 1.0 - 6.0 bar
Operating Temperature Min. 0°C / Max. 70°C

Notice : The provided technical data are the higher limits recommended in static condition. To obtain the correct dimensioning of the product, it is necessary to hold account of all the applicable dynamic forces, including the inertia of the manipulator, the configuration of the tools and the external forces applied.

Applications